Our RO-100MP pumped 4-stage RO system is a new type of aquarium filter. Water after it has been passed through an RO system has a reduced pH*. It is an excellent source to prepare appropriate conditions for aquatic organisms.
This system is equipped with four filtration stages, which are explained below.
If you want to achieve 0ppm, and your incoming TDS is above 200ppm, we would sometimes recommend that you install a secondary DI resin stage. This would depend on your starting TDS and and the application you require this unit for. @e would suggest calling our technical team to discuss your requirements further.
Our aquarium filter is factory tested and ready to use with connection hardware, tubing and instruction manual, all of which is designed to make installation and maintenance quick and easy without the need for a plumber.
It is offered as a complete set with filter cartridges, RO membrane, DI resin, additional accessories and valves to prevent the membrane from becoming dried out.
*pH of water after RO system depends on source water.
System dimensions (H x W x D): 160 x 155 x 345 (mm)
Working Temp.: 5°C – 40°C (41ºF – 104ºF)
Operating Pressure: 2.8 bar (40 psi) – 6.0 bar (90 psi) If your incoming water pressure is above 4 bar a pressure regulator should be installed.
Inlet feed water connector: 1/4”
Flow rate: 100 gallons-per-day
Typical Rejection Rate: 98% TDS (Total Dissolved Solids)
TDS (Total Dissolved Solids) < 1800 ppm pH Parameters: 2 – 11 Iron: 0.2 ppm maximum Turbidity < 5 NTU Pump Specifications: Flow: 0.75 l/min Model: TYP-2600 Max. inlet pressure: 25 psi Max. outlet pressure: 80.0 psi Dimensions (H x W x L): 25cm x 7cm x 7cm Working Current: 0.85A Power: 24V/DC Transformer Ampage: 2A Recommendations for Use: Point-of-Use (POU) systems will remove all unwanted contaminants that find their way into ground water supplies, directly affecting the quality of commercial and domestic mains water. Recommended especially for use with hydroponics and sensitive aquatic organisms requiring water that has been purged of dissolved solids and other particulate matter found in untreated water. Ideal also for household use, perfect for small families, kitchen compact and will easily fit into any under counter space. Complete Package Contains: The RO-100MP is supplied with the following cartridges: PP, CTO TYP-2600 100GPD Pump FDA approved water filter housings (including o'rings) Feed water connector (can be fitted to copper mains water pipe) RO membrane element type: RO-1812-100 thin film composite Drain saddle valve, spanners for filter and RO housings 10" transparent housing for DI resin chamber 630ML MB-115 mixed-bed colour-change DI resin 1/4" tubing for system connection (5 metres) 400cc flow restrictor, automatic and manual flush switch Automatic shut-off valve Instructions manual